AQUAPRO 2120 Water Based Dye Stain

Code: 2120

A water based dye stain to be applied directly over raw timber to enhance the natural appearance of the timber. It is available in 8 bright vibrant colours which can be blended to promote an unlimited colour range.

Features

Features

  • Versatile - Can be applied over all species of timber
  • Medium to slow dry, easy to apply - results in a uniform colour
  • Apply by brush, wiping, roller or applicator - no need to wipe off
  • Can be top coated with AQUAPRO water based, DURAPOL moisture cure, POLYTHANE two pack, NATUROIL oil finishes and FASTASEAL sealers
  • Good light stability of the dye stain
  • Low odour
  • Non-flammable, no requirements for precautions with oily rags and equipment
  • Water wash up

 

AQUAPRO 2120 Colour Stain Chart

Specifications

Specifications

Colour : Primary: #5000 Yellow, #7000 Red, #8000 Blue, #9999 Black. Premixed: #6001 Maple, #6004 Oak, #6007 Teak, #6008 Walnut
Thinner : AQUAPRO 1320 Slow or 133 Medium Reducer
Coverage : 10-12m2 per litre - coverage is dependent upon the porosity of the timber
Dry Time :
Refer to datasheet
Clean Up :
Water or AQUAPRO 1320 or 1330 reducer
Packaging : 1 & 5L
Product Code : 2120

Tech Data Sheet

Application

Application

Surface Prepartion:

Preparation: Prepare a test area to check colour and application. Prepare the surface by filling nail holes and imperfections with a water based putty in a colour close to the stain. Allow to dry. Sand floor per AS 4786.2-2005 standard to produce a defect and scratch free surface. Finish sanding with 120-180 screen back paper fitted to a rotary sanding machine. Ensure floor is defect and scratch free before applying the stain. Scratches and imperfections may be highlighted by the stain.

Mixing: Stir thoroughly before use.

Tools: Brush, rag, roller or applicator - wipe on and leave or wipe on wipe off.

Application:

  1. Reduce and mix enough stain for the entire project before starting. Work from one corner as you would when coating a room. Apply to strip flooring along the direction of the grain. Only cut in a small distance in front of your roller or pad applicator. DO NOT pour or pool stain on the floor. Even application of the stain is essential to ensure a uniform even colour.
  2. Allow the stain to dry before applying coatings (see recoat time).
  3. Ensure adequate coating is applied to seal AQUAPRO 2120 Stain to reduce the risk of sanding through the sealer coat. If this happens, it is possible to reapply the stain to these areas to re-colour the exposed timber.
  4. First Coat / Sealer product options: FASTASEAL 3030 Clear Sealer, FASTASEAL 3540 Clear Sealer, DURAPOL 1045, 5840, 1044, 1050, NATUROIL 3100, 3120 or POLYTHANE 2043 Two Pack.
  5. Second and Final coat: Any of the above plus, AQUAPRO 8270 Advance 2K or NATUROIL 3115 Low Sheen or DURAPOL Low Sheen coatings.

Where to Use

Where to Use

Interior use only. Timber floors, architraves, skirting boards, timber quadrant and beading.

To top