Whilst this problem is rare it is possible that solvent based coatings can react with poor quality wall paints and cause the paint to yellow. Refer to the technical bulletin “Yellowing of walls following application of solvent based coatings” for further information.
There are 3 main causes of delamination; Contamination of the underlying surface, Suitability of coating for surface being coated and inadequate surface preparation. Refer to the technical bulletin “Delamination” for further explanations of each of these main causes and how they can be prevented.
This will depend upon the type of coating, for example solvent based coatings have a much stronger odour than water based coatings. It also depends upon the ventilation and air movement in the room. As soon as the coating is dry it is recommended that doors and windows are opened to increase air movement.
Ideally remove curtains before coating the floor, however if they have not been removed washing them and allowing them to air dry should eliminate the odour.
It is unusual for the chemicals to get into a fridge or freezer unless there is a problem with the seal. However Polycure recommends removing all food and clothing items in all rooms connected to the coated areas. All food, fabrics and all absorbent items need to be removed to prevent the potential for them
To minimise the risk of scratching and scuffing after the floor has been coated, the following guidelines should be followed: Walking on floor with socks or stockings – After 24 hours. Replacing furniture – After 2-3 days (longer if possible). Replacing mats and rugs – After 3-4 weeks. Damp mopping – After 2-4 weeks. Provide ventilation to the
NATUROIL oil finishes dry by a process called oxidation. The oxidation process is accelerated by the incorporation of driers in the coating. The drying starts at the surface and gradually progresses to the bottom layer of the film. Frying refers to the softening, swelling and wrinkling of the dry coating by solvents upon recoat. All
Yes but it is recommended that NATUROIL 1499 Accelerator is added to speed up the drying time. Cold and damp environments will have an effect on drying time. In cold temperatures the coating may have to be left longer to dry between coats. Failure to do so may cause issues with the next coat i.e.
There are a number of factors that will affect the drying time of coatings. High film weights and pooling or ponding of the coating on the floor will slow the drying time. Low temperatures will affect drying time, where possible use accelerators to speed up drying (refer to individual product data sheets) where accelerators are
Use a good quality brush to cut in around edges and skirting boards and a good quality roller for the bulk of the area. The type of roller will vary by product type, refer to the appropriate product data sheet for further information.